Motorola Symbol CS3000 Series User Manual

4 - 12 Symbol CS3000 Series Scanner Product Reference Guide
User-Programmable Supplementals
Supplemental 1: Parameter # 0xF1 0x43
Supplemental 2: Parameter # 0xF1 0x44
If you selected a Supplemental User-Programmable option from Decode UPC/EAN Supplementals on page 4-8,
select User-Programmable Supplemental 1 to set the 3-digit prefix. Then select the 3 digits using the Numeric
Bar Codes on page 4-48. Select User-Programmable Supplemental 2 to set a second 3-digit prefix. Then select
the 3 digits using the Numeric Bar Codes on page 4-48.
User-Programmable Supplemental 1
User-Programmable Supplemental 2
Decode UPC/EAN Supplemental Redundancy
Parameter # 0x50
With Autodiscriminate UPC/EAN Supplementals selected, this option adjusts the number of times a symbol without
supplementals are decoded before transmission. The range is from 2 to 30 times. Five or above is recommended
when decoding a mix of UPC/EAN symbols with and without supplementals, and the autodiscriminate option is
selected.
Scan the bar code below to select a decode redundancy value. Next scan two bar codes from Numeric Bar Codes
on page 4-48. Single digit numbers must have a leading zero. To change the selection or cancel an incorrect entry,
scan Cancel on page 4-50.
Decode UPC/EAN
Supplemental Redundancy
(Default: 7)

Motorola Symbol CS3000 Series Specifications

General

Brand	Motorola
Model	Symbol CS3000 Series
Category	Scanner
Language	English