The NPort 6000 User Table may be used for to authenticate users for terminal or reverse terminal access and
is useful if you do not have an external RADIUS server for authentication. The NPort 6000 User Table stores up
to 64 entries, with fields for User Name, Password, and Phone Number.
Authentication Server
RADIUS server IP: If you are using a RADIUS server for user authentication, enter its IP address here.
RADIUS key: If you are using a RADIUS server for user authentication, enter its password here.
UDP port (default=1645): If you are using a RADIUS server, enter its UDP port assignment here.
RADIUS accounting: Use this field to enable or disable RADIUS accounting.
TACACS+ server: If you are using a TACACS+ server for user authentication, enter its IP address or domain
name here.
TACACS+ secret: If you are using a TACACS+ server for user authentication, enter its password here.
TACACS+ accounting: Use this field to enable or disable TACACS+ accounting.
System Log Settings
System Log Settings allow the administrator to customize which network events are logged by the NPort 6000.
Events are grouped into four categories, known as event groups, and the administrator selects which groups to
log under Local Log. The actual system events that would be logged for each system group are listed under
summary. For example, if System was enabled, then System Cold Start events and System Warm Start events
would be logged.
Local Log Keep the log into the flash of NPort 6000 up to 512 items.
Remote Log Keep the log into the remote defined Log Server.
You will need to assign a remote Log Server in the System Management /
To Next Page
Loading...
Need help?
General
