Moxa Technologies NPort 6000 Series - Configure the Remote Log Server

NPort 6000 Series System Management Settings
9-6
System
System Cold Start NPort 6000 cold start.
System Warm Start NPort 6000 warm start.
Network
DHCP/BOOTP/PPPoE Get
IP/Renew
IP of the NPort 6000 is refreshed.
NTP Time synchronization successful.
NTP Connect Fail The NPot 6000 failed to connect to the NTP Server.
Mail Fail Failed to deliver the E-mail.
IP Conflict There is an IP conflict on the local network.
Network Link Down LAN 1 Link is down.
Config
Login Fail
IP Changed Static IP address was changed.
Password Changed Administrator Password was changed.
Config Changed The NPort 6000’s configuration was changed.
Firmware Upgrade Firmware was upgraded.
SSL Certificate Import SSL Certificate was impoted.
Config Import Config was impoted.
Config Export Config was expoted.
OpMode
Connect Op Mode is in used
Disconnect Op Mode switched from in use to disconnect.
Authentication Fail The Authentication failed in terminal; reverse terminal; or dial in/out operation
modes
Restart Serial port was restarted.
Configure the Remote Log Server
SYSLOG server
IP address or domain name of remote log server.
SYSLOG facility
Syslog Facility is one information field associated with a syslog
message.
SYSLOG severity
Order of severity, listed from most severe to least severe.
0 Emergency
1 Alert
2 Critical
3 Error
4 Warning
5 Notice
6 Informational
7 Debug