6. Click Install to begin the installation. The setup window will report the progress of the installation. To
change the installation settings, click Back and navigate to the previous screen.
7. Click Finish to complete the installation of NPort Search Utility.
Configuring NPort Search Utility
The Broadcast Search function is used to locate all NPort 6000 servers that are connected to the same LAN as
your computer. After locating an NPort 6000, you will be able to change its IP address.
Since the Broadcast Search function searches by MAC address and not IP address, all NPort 6000 servers
connected to the LAN will be located, regardless of whether or not they are part of the same subnet as the host.
1. Open NPort Search Utility and then click the Search icon.
The Searching window indicates the progress of the search.
To Next Page
Loading...
Need help?
General
