Moxa Technologies NPort 6000 Series User Manual

NPort 6000 Series System Management Settings
9-21
Iface:
Name of the physical network interface.
Destination:
Network or host that the router allows you to connect to.
Gateway:
IP Address of the gateway you configured for this route. If you are directly connected, this is a
local address. Otherwise, it is the address of the machine through which packets must be routed.
Netmask:
Network pattern of the gateway.
Metric:
Number of hops to the destination.
Flags:
State of the route. Valid states are:
U up
D down
G route to a gateway
H route to a host
T setting in route table
R dynamic by RIP
Use:
Correct number of packets being sent in this route.
PPP-Trace
Go to PPP-Trace under System Status to display the PPP-Trace information.
PPP states for the selected ports are shown. LCP (Link Control Protocol), which is an essential
part of the PPP link, is used for establishing, configuring, and testing the data link connection
Dout State (for 6450/6600)
Dout State refers to the relay output status, which can be configured to change upon the occurrence of certain
system events through Auto Warning Settings under System Management. You may click Dout State
under System Status to display a list of events that may cause a change to the Dout state. If a configured
alarm event occurs, the alarm LED lights up and the Dout state changes, and you may come to this screen to
determine the specific cause for the alarm. To reset the Dout state, click on Acknowledge Event. Note that the
alarm LED will remain unchanged until the actual event has been resolved.

Moxa Technologies NPort 6000 Series Specifications

General

Brand	Moxa Technologies
Model	NPort 6000 Series
Category	Server
Language	English