NPort 6000 Series Configuration with the Web Console
Opening the Web Console
Open your web browser and enter 192.168.127.254 in the website address line. This is the default IP address
for the NPort 6000–if a new address has been assigned, enter the new address instead. Press ENTER to load
the page.
ATTENTION
The examples and figures in this chapter use the NPort 6000 factory default IP address of 192.168.127.254.
If you have assigned a different IP
address to your NPort 6000, be sure to adjust accordingly when following
these directions.
Please refer to Chapter 3, Initial IP Address Configuration,
for details on how to configure the
IP address.
The default login username is admin with no password. Note that only the user admin can upgrade the
firmware.
ATTENTION
If you forget your password, the ONLY way to configure the NPort 6000 is by using the reset button to reset
all settings and load the factory defaults. If
you have disabled the reset button in your NPort 6000
configuration, you may still use it to load the factory defaults within the first 60 seconds that the NPort 6000
is powered on.
up your configuration by exporting it to a file. Your con
figuration can be easily restored by
importing the file to the NPort 6000
. This will save time if you have forgotten the password and need
to reload
the factory defaults.
The NPort 6000’s web console will appear.
To Next Page
Loading...
Need help?
General
