MP Aquinity 2 E

To Next Page

To Previous Page

Exploded view v.1.0.

2018.04.11HaSFront panel (810-0512)

a b c d e f g h

Aquinity²E / Aquinity²P /

Aquinity²P10 / Astacus²

FRONTSIDE - VIEW

BACKSIDE - VIEW

CPU with Display

820-0725

USB

860-1996

Reset

860-2002

Main Page

Table of Contents3
General6
About this Manual6
Symbols Used in this Manual6
Liability and Warranty7
Copyright7
Spare Parts8
Disposal8
Safety9
Intended Use9
Contents of this Manual9
Changes and Modifications to the Equipment10
User Responsibility10
Personal Requirements10
Health and Safety Work11
Personal Protective Equipment (PPE)11
Potential Hazards11
System Features13
General13
Series Overview14
Technical Data14
Purification Process15
EDI-Cell in Aquinity² E16
Conditioning Module in Aquinity² P17
Purification Elements in Aquinity² E and Aquinity² P17
TOC Monitoring (TOC Systems Only)19
Hardware20
Dispenser20
Control PCB20
IEC Socket21
Front- and Side-Panel21
Installation and Start up22
Feed Water Requirements22
Delivered Parts23
Hydrogen Warning (for Aquinity² E)24
Setting up the System24
Sealing Plug24
Connections25
Module Attachment26
Vent Filter Attachment26
Sterile Filter Attachment27
Electrical Connection27
Initial Start-Up27
Normal Start29
System Control Panel30
Normal Operation Mode30
Tools30
Exchanging Consumables30
Exchanging UV-Lamp (in the Pure Water Section)32
Exchanging UV Submersible Lamp (in the Tank)32
Change All Consumables33
Exporting Data33
Prod. to Max Level34
Disinfection34
Process Visualization (System-Status)35
Venting UPW36
History36
Warning Messages36
Graphical Values36
Logfile37
User Setup37
Limits Setup37
System Time Settings38
Reset Timers(Manually)38
Operating Hours39
Manual Stand by39
Errors and Countermeasures40
Care and Maintenance42
Intervals42
Replacement of Sterile-Filter42
Modul Replacement43
Replacement of the UV-Lamp44
Replacement of UV-Submersible-Lamp45
Replacement of Ultrafiltration Module46
Disinfection (UF-Systems Only)46
Replacement of Reverse Osmosis Module48
P&I Scheme (Aquinity² E)49
P&I Scheme (Aquinity² P)50
Consumables51
System Update51
Users Faq's53
Contact53
Service Setup54
Adjustment Conductivity Sensors Q and Temperature T54
Limit Setting of Conductivity Sensors55
Tank Setup55
Read Operating Hours56
Limit Operating Hours56
Command Line56
System Info. (System-Information)57
First Start58
Direct Access58
Reset Configuration59
Reset Calibration59
Flushing, Disinfection Timer59
Editor .Mcf-File60
Touchscreen Calibration61
Conductivity Measuring Amplifier62
Calibration of the Conductivity and Temperature Measurement62
Control Board64
Single Board Computer65
Software Parameters66
Configuration File (Config.mcf)66
Calibration File (Calib.mcf)68
Operating Hours File (Op_Hour.dat)69
Services Faq's69

MP Aquinity 2 E - Page 92

Table of Contents