Installation and start up
membraPure GmbH
Wolfgang-Küntscher-Str.14
16761 Hennigsdorf
Germany
Tel.: +49 (0) 3302/201-20 0
Fax.: +49 (0) 03302/201-20 21
E-Mail: info@membrapure.de
Internet: www.membrapure.de
The system prompts to turn on the submersible lamp and
install the sterile filter.
- Turn on the submersible lamp by plugging the power
adapter into an electrical outlet
Install the sterile filter (see chapter 4.9).
The system is in normal operation and fully operational now.
- At first water dispensing please open the deaeration
screw for a short time to vent the sterile filter (see
Figure 13: sterile filter).
Finally do system time correction (see Chapter 5.4.2)
Discard after short-term interruption (eg weekend) the first
100ml of water abstracted
4.12 Normal start
- This is the first display after connecting to the mains.
The system jumps to the start screen.
- If „Skip“ is selected the system starts the normal
operation mode immediately.
- This first display is only recallable through a reset
function which is implemented in the control.
To Next Page
Loading...