MPI 40 Series - Installation and Operation; Introduction; Unpacking

SECTION 2
INSTALLATION AND OPERATION
2.1 INTRODUCTION
This section provides mounting information and procedures necessary
for proper installation and operation of the Model 40 Series Disk Drives.
2.2 UNPACKING
I CAUTION I
During unpacking, care must be exercised
to ensure that all tools are non-magnetic
and do not inflict damage to the unit.
As the unit is unpacked, inspect it for possible shipping damage. All
claims for this type of damage should be filed promptly with the transporter
involved. If a claim is filed for damages, save the original packing mater-
ial. Most packing material may be reuseable if reasonable care is used in
unpacking. If reshipment is required, be sure to insert the shipping disk
that was shipped with the unit and close the door. Unpack the drive as
follows:
A. Remove external packing material carefully.
B. Remove the drive from the container.
c. Remove internal packing materials.
D. Ensure that front access door opens and closes, and that the
head-load arm raises when door is opened.
E. Ensure that bezel is secured.
F. Ensure that drive hub manually rotates freely.
G. Ensure that stepper motor/head carriage assembly is not binding at
any point by manually moving carriage back and forth.
2-1