OPERATING AND MAINTENANCE MANUAL
Risk analysis: residual risk
HAS T 070÷140
99
The data in this manual are not binding and they can be modified by the manufacturer without notice. Reproduction of this manual is strictly prohibited
EN
ENGLISH
12. Electrical hazard: heat radiations or
other phenomena, such as projection of
melted particles, and chemical effects
deriving from short circuits, overloads.
Risk of electrocution with live parts
due to short circuits, scalding on
contact with hot components due to
overload.
Strictly observe all manual
instructions. Chapter 2 “Safety” and
4.3.5 “Electrical connections”
13. Heat-associated risk: burns and/or
scalding
Scalding on contact with pipelines at
temperatures over 65°C and/or
freezing due to contact with surfaces
at temperatures below 0°C.
Strictly observe all manual
instructions. Chapter 2 “Safety”
14. Hazards generated by noise levels that
may impair hearing capacity
(deafness) and other physical disorders
(such as loss of balance,
consciousness).
Loss of hearing capacity by operator. Secure all components correctly after
interventions and maintenance.
15. Hazards generated by materials or
substances handled, used, produced or
offloaded from the machine and by
materials used to construct the
machine: inhalation of refrigerant
gases.
Inhalation of refrigerant gas. Strictly observe all manual
instructions. Chapter 2 “Safety”
16. Hazards generated by materials or
substances handled, used, produced or
offloaded from the machine and
materials used to construct the
machine: fire or explosion.
Risk of fire or explosion. Install the system in an environment
fitted with adequate fire fighting
equipment. Strictly observe all
manual instructions.
Chapter 4 “Installation”
17. Hazards generated by failure to use
personal protective equipment.
Lacerations to upper limbs during
maintenance or installation.
Use adequate personal protective
equipment and observe all
instructions in the manual.
Chapter 1 “General information”;
Chapter 2 “Safety”; Chapter 4
“Installation” and Chapter 8
“Operation and maintenance”
18. Hazards generated by failure to
observe principles of ergonomics
during machine design, caused, for
example, by: inadequate design, layout
or identification of manual controls.
Hazards associated with failure to
correctly identify manual controls.
Consult all sections of the manual.
19. Hazards generated by failure to
observe principles of ergonomics
during machine design, caused, for
example, by: inadequate design, or
layout/location of visual display units.
Hazards associated with failure to
correctly understand visual display
units.
Consult all sections of the manual.
20. Inadvertent start-up, overtravel/
unexpected excess speed (or any other
similar malfunction) caused by: fault
or malfunction of control system.
Electrical or mechanical hazard due
to incorrect settings of operating
parameters or settings.
Strictly observe all manual
instructions.
Chapter 2 “Safety”; Chapter 8
“Operation and maintenance”; 4.3.5
“Electrical connections” and Chapter
4 “Installation”
21. Inadvertent start-up, overtravel/
unexpected excess speed (or any other
similar malfunction) caused by: fault
or malfunction of control system with
possibility of disabling safety devices.
Electrical hazard during interventions
on machine with safety devices
inhibited.
Strictly observe all manual
instructions. Chapter 2 “Safety”;
4.3.5 “Electrical connections”;
Chapter 4 “Installation” and Chapter
8 “Operation and maintenance”
22. Inadvertent start-up, overtravel/
unexpected excess speed (or any other
similar malfunction) caused by: fault
or malfunction of control system.
Electrical hazards associated with
environmental work conditions.
Strictly observe all manual
instructions. Chapter 2 “Safety”;
Chapter 4 “Installation” and 4.3.5
“Electrical connections”
Description of risk: Effect: User instructions:
To Next Page
Loading...