Multiplex COCKPIT SX MLINK - The Transmitter; First Use; The Binding Procedure; Transmitter Settings and Information Displays

MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de Page 17
Supplement to COCKPIT SX operating instructions, firmware version V3.xx and later # 985 5334 (10-07-21/MIWA) • Errors and omissions excepted! •
¤
MULTIPLEX
COCKPIT SX M-LINK
firmware version V3.04 and later
Supplementary
COCKPIT SX operating instructions (35/40 MHz)
Dear customer,
Dear fellow-modeller,
This supplement to the Cockpit SX operating instructions covers the points which have been changed with the intro-
duction of our new 2.4 GHz M-LINK transmission system for the Cockpit SX M-LINK.
In detail these are:
Page
Changes in firmware version V3.xx and later............................................................18
2. Introduction..................................................................................................................19
3. Safety Notes .................................................................................................................19
3.2. Range checking .....................................................................................................................................19
6. CE Conformity Declaration .........................................................................................20
7. Specification.................................................................................................................20
7.1. Use with restricted frequency range (France mode)................................................................................20
7.1.1. Preparing the transmitter........................................................................................................................21
9. The transmitter.............................................................................................................21
9.5.1. Transmitter aerial...................................................................................................................................21
10. First use........................................................................................................................21
10.1. Charging the transmitter battery.............................................................................................................21
10.2. The binding procedure ...........................................................................................................................21
10.2.1. Prepare the transmitter ..........................................................................................................................21
10.2.2. Switch the receiver on............................................................................................................................22
10.2.3. Binding successful .................................................................................................................................22
10.2.4. Binding not possible...............................................................................................................................22
10.3. Switching on (normally)..........................................................................................................................22
10.3.1. Switch the transmitter on........................................................................................................................22
10.3.2. Switch the receiver on............................................................................................................................22
10.3.3. If the receiver fails to find the transmitter ................................................................................................22
10.3.4. Moving to the menus without an RF signal .............................................................................................22
10.4. What to do if TH >0 appears on the screen? ......................................................................................23
10.5. The RF Status indicator (blue LED)........................................................................................................23
10.6. General notes ........................................................................................................................................23
12. Transmitter settings and information displays .........................................................23
12.1. Transmitter settings, Menu: (SETUP) TRANSM.....................................................................................23
12.1.1. Full transmitter reset, Menu: (SETUP, TRANSM) RESET .....................................................................23
12.2. The INFO displays .................................................................................................................................24
12.2.1. Display of the actual receiver battery voltage..........................................................................................25
12.2.2. Display of the LQI value (Link Quality Indication)....................................................................................25
12.2.3. Connecting external M-LINK sensors .....................................................................................................25