The input passes through a 7-point curve before mixing. You can
choose from 8 curves. The same curve can be used for multiple
inputs in different mixers. This eliminates extra configuration effort.
When scrolling through the 3rd column of the mixer definition you will see any
combination of the icons described above in the following order:
Symmetrical, for surface pairs moving in opposite directions
Symmetrical, for surface pairs moving in opposite directions with
offset
Symmetrical, for surface pairs moving in opposite directions with
deadband
Symmetrical, with deadband
Asymmetrical, for surface pairs moving in opposite directions
Single-sided, with offset
Single-sided, with deadband
Single-sided, with additional set point at half travel
Curve mixer: The mixer input passes through one of 8 control
curves.
Curve mixer as described above, for surface pairs moving in
opposite directions
To Next Page
Loading...
Need help?
General
