Creating and customising models
Editing the model name
The new model that is created has the same name as the template used: HELIccpm.
For easier reference, you should change the name to the actual model name:
7. Open the Memory > Edit name menu.
8. Enter a name (max. 16 characters) that clearly identifies the model. Refer to
page 157 for details.
The creation of a new model in the memory is now completed. These settings
determine the following in the model memory:
Receiver output sequence
o Servo 1 to 6 are pre-defined
o The servo assignments can be changed and amended as required
(Servo > Assignment menu).
Controls assignment from the template
Controls are assigned to control functions in the Setup > Assign.Controls
menu:
Collective is assigned to the same control
as Throttle
Left-hand slider for gyro sensitivity
Right-hand slider for Thr.Limiter
To Next Page
Loading...
