Disk Image Backup and NCRImage Recovery Tool 5-93
Saving an Image
The Select Image Location screen displays a terminal with three sets of In/Out arrow
buttons, indicating the direction of data flow when selected. Arrows pointing away from
the terminal are used to Save images to a device. Arrows pointing towards the terminal
are used to Load an image.
Recovery Partition Size
The size of the Recovery Partition is limited to 8GB on the local drive. The USB and
network options can be used to store / backup larger images. The total size is comprised
of the base factory image + the user and site backups and the roughly 300MB of space
used by WinPE and apps. USB/Network backups are limited only by the hardware that
they are being stored to.
After the factory image is copied into the Recovery Partition, there is approximately 3GB
remaining in the 8GB partition. Any data stored as an incremental backup to this
location is compressed. A typical, large POS software installation will not outpace the
constraints of the local storage.
To Next Page
Loading...
Need help?
General
