Chapter 6: SLES 15 SP4 Software RAID Gold
Master Image
The following procedure incorporates software RAID into an NCR supported terminal
running SLES 15 SP4 distribution. The software RAID configuration is set to RAID1
mode.
Note: For more information about RAID, refer to SLES 15 SP4 | Storage Administration
Guide | Configuring software RAID for the root partition (suse.com).
RAIDpartitioning is done by using the SLES Expert Partitioner during installation of
the OS.
Note: The succeeding screenshots are from an NCR terminal with two 480GB hard
disks:
• nvme0n1—disk 1
• nvme1n1—disk 2
1. In the Suggested Partitioning screen, from the Expert Partitioner dropdown list,
select Start with Current Proposal.
To Next Page
Loading...
