NCR CX5 - Chapter 8: BIOS Setup; Entering Setup; Selecting Menu Options; Enabling ONESHOT

Chapter 8: BIOS Setup
Entering Setup
1. Connect an alphanumeric USB keyboard to the terminal.
2. Apply power to the terminal.
3.
When you see the NCR logo displayed, press [Del] or [F2].
Selecting Menu Options
The following keyboard controls are used to select the various menu options and to
make changes to their values.
• Use the arrow keys to select (highlight) options and menu screens.
• Use the [Enter] key to select a submenu.
• Use the [+] and [-] keys to change field values.
• To view help information on the possible selections for the highlighted item, press
[F1].
• To save the changes, move the cursor to the Save and Exit Menu, select Save
Changes & Reset, and press [Enter].
Enabling ONESHOT
When the Power Switch is pressed for four seconds, the hardware level override of the
processor forces an uncontrolled shutdown. This can corrupt the Operating System. The
ONESHOT feature disables this hardware override. To turn on the ONESHOT feature,
follow these steps:
1.
Enter BIOS Setup using the [Del] or [F2] hotkey.
2.
In Setup, go to Advanced → NCRPOS → ONESHOT Control.
3.
Set the ONESHOTControl setting to ENABLED.
4.
Press [F4] to save and exit.