NCR CX5 - Connecting to a Network; CX5 with Base or Remote I;O; CX5 with Integrated I;O

2-56 Hardware Installation
Connecting to a Network
Most business configurations require the terminal to connect to a network. Connecting
to a network enables communicating with other systems and devices also on the
network. Depending on business configurations, connecting to a network may allow
connection to the Internet.
CX5 with Base or Remote I/O
To connect the CX5 terminal with a Base or Remote I/O to a network, follow these steps:
1. Connect the 10/100/1000 Ethernet Cable to the port labeled LAN In on the I/Opanel.
For more information, refer to I/O Ports on page22.
2. Connect the other end of the 10/100/1000 Ethernet Cable to the network hub.
Note: Consult with your business Information Technology (IT) representative to
determine the available connection, and to locate the network hub.
3. Connect the Flat Ethernet Cable to the port labeled LANOut on the I/Opanel. For
more information, refer to I/O Ports on page22.
4. Connect the other end of the Flat Ethernet Cable to the port labeled LANon the
CXHead. For more information, refer to CXHead Ports on page18.
CX5 with Integrated I/O
The Integrated I/O does not have a LANport. ALANPort is available on the
Motherboard. To connect the CX5 terminal with an Integrated I/O to a network, follow
these steps:
1. Connect the Ethernet Cable to the port labeled LANon the Motherboard.