-11- Power On/Off
Power On/Off
You can use your handset after set up of the e616 is completed. This section describes how to turn the power
on/off, how to enter the PIN code, and how to set the clock to use the e616.
Power On/Off
You can power on or off on the e616. Proceed as described below.
To Power On
1 Ensure that your USIM card is in your e616 and that the battery is charged.
2 Press and hold the End (On-Off) key until power is on.
The term “press and hold” is equivalent to a key press time of approximately 2 seconds.
To Power Off
In standby mode, press and hold the End (On-Off) key until power is off. There may be some delay while the
handset powers down. Do not repower the handset during this time.
To Next Page
Loading...
