Making and Receiving Calls -14-
Making a Voice Call
Voice calls can be made by using the Contact list, directly inputting numbers using the keypad, or by using
the Incoming calls/Outgoing calls list, Missed calls list, Speed dial or One touch dial function. You can also
select a number in a message and call that number. A maximum of 36 digits can be entered to make a call.
For international calls, up to 37 digits including the international code "+" (press and hold 0) can be entered to
dial. When the USIM card supports Alternate Line Service (ALS), the call will be made from the selected line
number.
When a call is made and e616 has an active outgoing call restriction setting, the call will be rejected. When
the receiver of a call has incoming call restriction setting active, the call will also be rejected. In both cases
the reason the call was rejected will be displayed as a message on the screen. (Refer to Call restrictions on
page 143 for details.)
Rejected calls will be diverted to the number registered in "Call forwarding > If busy". This is usually
defaulted to voicemail, depending on the network provider.
Basic Operations
The basic operations for making a voice call are shown below:
To Make a Voice Call
To Do This
1 Input the phone number Input the phone number using the keypad.
Note : To correct mistakes, press the C key briefly to delete the
last number, or press and hold the C key to repeat
deleting.
2 Dial the phone number Press the Start key.
3Talk
4 End the call Press the End key.
Note : When the headset is connected, closing the handset will
not end the call.
To Next Page
Loading...
