-35- Text Entry
In the Delete mode, press the C key to delete the character highlighted by the cursor. Pressing and holding
the C key will repeat this operation.
To Copy and Paste the Text
To copy and paste text, proceed as described below:
To Cut and Paste the Text
To cut and paste text, proceed as described below:
To Do this
1 Activate the copy function Press the Options menu key in the text input mode, then
select Copy.
2 Specify the copy starting point Move the cursor to the starting point of the block to copy by
using the Up, Down, Left, or Right key and press the Enter
key.
Note : You can cancel the specified copy starting point by
pressing the C key.
3 Specify the copy ending point Move the cursor to the ending point of the block to copy by
using the Up, Down, Left, or Right key and press the Enter
key.
Note : Maximum capacity of clip board is 1024 byte.
4 Specify the paste point Move the cursor to the paste point by using the Up, Down,
Left, or Right key.
5 Paste the block Press the Options menu key in the text input mode, then
select Paste.
Repeat the steps one to four if necessary.
Note : If the copied text exceeds the maximum number of
characters allowed in the field, the message asking
whether you want to discard the remaining characters or
cancel the paste operation.
To Do this
1 Specify the cut function Press the Options menu key in the text input mode, then
select Cut.
To Next Page
Loading...
Need help?
General
