Text Entry -36-
2 Specify the cut starting point Move the cursor to the starting point of the block to cut by using
the Up, Down, Left, or Right key and press the Enter key.
Note : You can cancel the specified cut starting point by
pressing the C key.
3 Specify the cut ending point Move the cursor to the ending point of the block to cut by using
the Up, Down, Left, or Right key and press the Enter key. The
specified text is cut.
Note : Maximum capacity of clip board is 1024 byte.
4 Specify the paste point Move the cursor to the paste point by using the Up, Down,
Left, or Right key.
5 Paste the block Press the Options menu key in the text input mode, then
select Paste.
Repeat the steps one to four if necessary.
Note : If the copied text exceeds the maximum number of
characters allowed in the field, the message asking
whether you want to discard the remaining characters or
cancel the paste operation.
To Do this
To Next Page
Loading...
