NEC e616 - Showing and Hiding Your CLI

Making and Receiving Calls -28-
Showing and Hiding Your CLI
You can show/hide your 3 number when you make or receive a call. As a default setting, your 3 number is
shown to the caller or the receiver.
To hide your 3 number when making a call, subscribe to the Calling Line Identification Restriction (CLIR)
service. There are two CLIR service subscription settings: permanent and temporary. When permanent CLIR
subscription is set, your 3 number will always be hidden when making a call. When temporary CLIR service is
subscribed to, you can turn on/off this function from Settings, or just input #31#/ 31# before a phone
number to hide/show your 3 number for that particular call.
When forwarding a call, the Connected Line Identity Restriction (COLR) service will hide the forward
destination phone number from the caller.
When making a call, the receiver’s identity (phone number) can be displayed on your handset’s display if you
subscribed to the Connected Line Identity Presentation (COLP) service, and your 3 number will be notified to
the receiver if you have subscribed to the Calling Line Identity Presentation (CLIP). The current subscription
status of these settings can be found and displayed from Settings. (Refer to Settings on page 133 for
details.)
Setting the handsfree mode Press the Options menu key and select Handsfree. Select
Handsfree on, or Handsfree off.
When the handsfree function is turned on, the microphone
sensitivity increases, and the other party’s voice is heard
from the speaker.
Adjusting the colour contrast Press the Options menu key and select Contrast settings.
Select Much brighter, Brighter, Standard, Darker, or
Much darker.
Setting the lighting mode Press the Options menu key and select Lighting settings.
Select Sunny, Cloudy, Automatic, or Indoors.
Setting the call time duration
information
Press the Options menu key and select Other settings and
Show call length. Select Show call length or Do not show.
Adjusting the speaker volume Press the Up and Down keys or the side keys.
Operation Procedure