Document Revision 1 Electra Elite IPK II
2 - 166 Central Office Calls, Answering
Programming
10-03-03 ETU Setup, For SLIU Unit - Transmit CODEC Gain Type
10-03-04 ETU Setup, For SLIU Unit - Receive CODEC Gain Type
Customize the transmit and receive levels of the CODEC Gain Types for 500/2500 type single
line telephones.
10-08-01 Pre-Ringing Setup
Enable (1) or disable (0) pre-ringing for outside calls. This setting affects all system trunks. This
sets how a trunk initially rings a telephone. With pre-ringing, a burst of ringing occurs as soon as
the trunk’s LED flashes. The call then continues ringing with the normal ring cadence cycle.
Without pre-ringing, the call starts ringing only when the normal ring cadence cycle occurs. This
may cause a ring delay, depending on when call detection occurs in reference to the ring cycle.
11-11-13 Service Code Setup (for Setup/Entry Operation) - Display Language Selection for
Multiline Terminals
Select the service code which can be used at an extension to change the displayed language on
a multiline terminal’s display (default: 678).
11-12-30 Service Code Setup (for Service Access) - Specified Trunk Answer
If required, redefine the service code used to answer a specific trunk which is either ringing or on
hold (default: 672).
14-01-02 Basic Trunk Data Setup - Transmit CODEC Gain Type
14-01-03 Basic Trunk Data Setup - Receive CODEC Gain Type
Customize the transmit and receive levels of the CODEC Gain Types for each trunk.
Trunks: 1~200
14-02-02 Analog Trunk Data Setup - Ring Detect Type
For each trunk, enable delayed ringing (0) or immediate ringing (1).
Trunks: 1~200
14-05-01 Trunk Groups
Assign trunks to trunk groups then go to Program 14-06-01 below to set up Trunk Group
Routing.
Trunk Groups: 1~100
14-06-01 Trunk Group Routing
Set up trunk routes and then go to Program 23-03-01 below to assign the trunk routes to
extensions. An extension user can use Universal Answer to answer a call if the ringing trunk is in
its assigned route.
Trunk Group Routes: 1~100
To Next Page
Loading...
