Electra Elite IPK II Document Revision 1
Pulse to Tone Conversion 2 - 685
Pulse to Tone Conversion
Description
An extension can use Pulse to Tone Conversion on trunk calls. Pulse to Tone Conversion lets a user
change their extension’s dialing mode while placing a call. For systems in a Dial Pulse area, this permits
users to access dial-up OCCs (such as MCI) from their DP area. The user can, for example:
J
Place a call to an OCC over a DP trunk.
J
Depending on programming:
Manually implement Pulse to Tone Conversion
- OR -
Wait 10 seconds.
J
Dial the OCC security code and desired number. The system dials the digits after the conversion
as DTMF.
Conditions
Pulse to Tone Conversion is only valid for Dial Pulse trunks (Program 14-02-01, options 0 or 1).
Default Setting
Enabled
System Availability
Terminals
All Multiline Terminals
Required Component(s)
COI(4/8)-U10 ETU, COID4/8-U10 ETU, COIB(4/8)-U( ) ETU
- or-
TLI(2)-U( ) ETU
- or-
DTI-U( ) ETU assigned for CO or Tie Line mode
To Next Page
Loading...
