NEC ELECTRA ELITE IPK II - Table 2-24 Keys for Entering Names

Electra Elite IPK II Document Revision 1
Station Name Assignment - User Programmable 2 - 795
To program any extension’s name:
1. Press the Speaker key.
2. Dial 700
- OR -
Press the Extension Name Change key (PGM 15-07 or SC 751: 55).
3. Enter the extension number to be named.
4. Enter a name. (Refer to Table 2-24 Keys for Entering Names.).
 The name can be up to 12 digits maximum.
5. Press the Hold key.
6. Press the Speaker key to hang up.
Table 2-24 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1
Enter characters:
1 @ [ ¥ ] ^ _ ` { | } Æ ¨ Á À Â Ã Ç É Ê ì ó
2
Enter characters A-C, a-c, 2.
3
Enter characters D-F, d-f, 3.
4
Enter characters G-I, g-i, 4.
5
Enter characters J-L, j-l, 5.
6
Enter characters M-O, m-o, 6.
7
Enter characters P-S, p-s, 7.
8
Enter characters T-V, t-v, 8.
9
Enter characters W-Z, w-z, 9.
0
Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü α ε θ
,
Enter characters:
, + , - . / : ; < = > ? B E σ S ∞ ¢ £
#
# = Accepts an entry (only required if two letters on the same key are needed
- ex: TOM). Pressing # again = Space. (In system programming mode, use
the right arrow Softkey instead to accept and/or add a space.)
CONF
Clear the character entry one character at a time.
HOLD
Clear all the entries from the point of the flashing cursor and to the right.