Electra Elite IPK II Document Revision 1
Distinctive Ringing, Tones and Flash Patterns 2 - 331
Distinctive Ringing, Tones and Flash Patterns
Description
Distinctive Ringing, Tones and Flash Patterns provide extension users with audible and visual call status
signals. This lets users tell the types of calls by listening to the ringing/tones and watching the keys. It
also helps users monitor the progress of their calls. In addition, Distinctive Ringing lets multiline terminal
users customize their Intercom and trunk call ringing. This is helpful for users that work together closely.
For example, if several co- workers set their multiline terminals to ring at different pitches, the co-workers
can always tell which calls are for them. You can also customize the tones the system uses for splash
tone, confirmation tone, trunk ring tone, Intercom ring tone and Alarm ring tone. Refer to the chart below
and the Electra Elite IPK II Programming Manual for more details
.
Conditions
Single line telephone users cannot listen to or hear the pitch of their telephone’s incoming
ring.
DTU/DTP Style phones will only follow high, mid range and low ring tone settings. They will
not follow Melodies.
If 22-03-01 is set to 0~3 and 15-02-02 is set to 1~3 trunk calls will follow the ring pattern in
22-03-01 and the pitch in 15-02-02.
If 22-03-01 is set to 4~8 and 15-02-02 is set to 1~3 trunk calls will follow the ring pattern in
22-03-01.
If 22-03-01 is set to 0~8 and 15-02-02 is set to 4~8 trunk calls will follow the ring pattern in
15-02-02.
Default Setting
Enabled
Table 2-10 Distinctive Ringing: Tones and Flash Patterns
Program Description
80-01-01~04 Service Tone Setup Set the frequency of the system’s splash tone. This is the tone the
system uses, for example, to alert the user of an incoming
voice-announced Intercom call.
30-05-02~21 DSS Console Lamp Table Set the DSS and Hotline key flash rates for busy, idle, DND, ACD
Agent status, and hotel options.
To Next Page
Loading...
