Electra Elite IPK II Document Revision 1
Code Restriction, Dial Block 2 - 213
Code Restriction, Dial Block
Description
Code Restriction-Dial Block lets a user temporarily block an extension’s Code Restriction. This helps a
user block his or her phone from being used by another person while they are away from their desk. A
user would need to enter a 4-digit personal code to enable/disable this feature.
Dial Block can also be set by the supervisor’s access code. If Dial Block has already been set by an
extension user, the supervisor can not release it. Additionally, if Dial Block has been set by the
supervisor code, the extension user can not release it.
Important: This function works by password and Class of Service control (the supervisor is not an
assigned extension). If Dial Block is available for all Classes of Service, everyone may become a
supervisor if they know the Dial Block password.
Conditions
If the system is reset by a first initialize, the Dial Block feature is cleared.
This feature is not available for ISDN S-Bus extensions.
Both Programs 21-09-01 (Code Restrict Class) and 21-10 (Dial Block Restriction Class per
Extension) can be set at the same time.
The system gives priority to the setting in Program 20-10.
Dial Block can temporarily block an extension’s Code Restriction setting by changing to a
pre defined table that has more restrictions.
Default Settings
Disabled
System Availability
Terminals:
None
To Next Page
Loading...
