NEC ELECTRA ELITE IPK II - Table 2-15 Hardware;Software Requirements for Running Webpro

Document Revision 1 Electra Elite IPK II
2 - 662 PC Programming
 The hardware/software requirements for the host PC running WebPro are:
 Only one PCPro/WebPro/Handset can be programming the switch at any one time.
 When programming via WebPro/PCPro, some data requires you to logout before the switch
will fully apply the changes. These programs are: 10-21-2, 11-02 (for directory dial), 11-04
(for directory dial), 13-04 (for directory dial), 14-04, 15-05, 15-15, 16-02, 23-02, 31-02,
41-02, 41-17, 47-02, 47-03, 82-11, 83-11.
 Some PRG items require second initialization of the KTS before they take effect. These
programs are: 10-12-01, 10-12-02, 10-12-03, 10-12-04, 10-13-01, 10-13-02, 10-13-03,
10-14, 10-15, 10-16-01, 10-16-02, 10-16-03, 10-16-04, 20-01-03, 47-01-01, 80-01,
80-02-01, 80-02-02, 80-02-03, 80-02-04, 80-03, 80-04, 84-03-01, 84-03-02, 84-03-06,
84-03-07, 84-03-08, 84-05-01, 84-05-02, 84-06-01, 84-06-02, 84-06-03, 84-06-04,
84-06-05, 84-06-06, 84-06-07, 84-06-08, 84-06-09, 84-06-10, 84-06-11, 84-09, 84-10.
Default Setting
None
TCP Port
If using IP connections, PCPro needs TCP
port 8000 to be open between the KTS and
the host PC, because communication
between PCPro and the KTS occurs on this
port.
Screen Resolution
800 x 600 (minimum)
1024 x 760 (recommended)
Table 2-15 Hardware/Software Requirements for Running WebPro
Item Requirement
Browser MS Internet Explorer 6.0 (or higher)
Mozilla Firefox 1.0.3 (or higher)
Network IP connection to the KTS
Screen Resolution 800 x 600 (minimum)
1024 x 760 (recommended)
Table 2-14 Hardware/Software Requirements for Running PCPro (Continued)
Item Requirement