EasyManua.ls Logo

NEC ELECTRA ELITE IPK II - Table 2-12 Restrictions for Calling Party Names

NEC ELECTRA ELITE IPK II
996 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Electra Elite IPK II Document Revision 1
ISDN Compatibility 2 - 517
J
ISDN maintenance functions (such as In Service/Out of Service Messaging)
J
Speech and 3.1 KHz audio
PRI capability requires the installation of DTI-U40 ETU with PRT Firmware version 5.XX or
higher. Each ETU (also called a PRI circuit) provides 24 PRI channels (23B + D) 4 with 64K
Clear Channel response. The T1/PRI Interface ETU uses a single slot. When installed, the
T1/PRI Interface ETU uses the first block of 24 consecutive trunks. For example, if you
have an COI (8)-U( ) ETU installed for trunks 1-8, the T1/PRI Interface ETU will
automatically use trunks 9-32. If you have COI (8)-U( ) ETUs installed for trunks 1-8 and 17-
24, the T1/PRI ETU will use trunks 25-48. The T1/PRI Interface cannot use trunks 9-16
(even if available) since they are not part of a consecutive block of 24 trunks.

Restrictions for Calling Party Name:
The Electra Elite IPK II supports receiving the name from the Network in supported formats
only and cannot send the Calling Name. Refer to the following table.

CO Line Service is not supported.
ISDN –PRI cannot be configured for CO Emulation

B-Channel to Trunk Association
When an Incoming ISDN-BRI/PRI call is received, the system will assign the lowest trunk
number of the ISDN circuit to the incoming call associated with the B-Channel. When an
Outgoing call is placed using the ISDN-PRI/BRI, the system will assign the Trunk and B-
Channel association according to the chart below. This is based on the Trunk to Trunk
Group and Trunk Group Priority assignment in (PRG 14-05-01).
Refer to the charts below for examples:
Table 2-12 Restrictions for Calling Party Names
Protocols Name Delivery Formats
NI-2 Facility Information Elements
4ESS (AT&T Custom) Not Supported
AT&T5ESS Lucent Custom Facility Information Element
DMS-100 (Custom)
,
Display Information Element *
DMS-100 (National; ISDN)
,,
Facility Information Element**
,
Nortel Specification NIX-A211-1
,,
Nortel Specification NIS-A233-1
Incoming Call
Trunk
Number
B-Channel
Number
Station User 9 1

Table of Contents

Other manuals for NEC ELECTRA ELITE IPK II

Related product manuals