Electra Elite IPK II Document Revision 1
Resident System Program 2 - 701
Resident System Program
Description
When power is supplied to the system, the hardware configuration is scanned and Resident System
Program default values are assigned including terminal types (e.g. PGD(2)-U10 ADP, DSS Console).
This enables immediate operation, even before the system is programmed to accommodate the
individual site requirements.
Conditions
Default assignments for Multiline Terminals are: LK 01~ LK 08 corresponds to
CO 01 ~ CO 08.
DSS Console to Extension assignments for Attendant Add-On Consoles are not assigned.
Default Attendant Add-On Console key assignments are:
DSS Keys = 001~060
Stations = 101~160
First Initialization of the system returns all programming values to default. Without a
PC-ATA Compact Flash Card installed, press and hold the SW1 (Load Switch) and toggle
the Reset (SW2) switch. Continue to hold the SW1 switch for approximately 5~10 seconds
before releasing. The system boots loading Resident System Programming.
Default Setting
None
System Availability
Terminals
Not Applicable
Required Component(s)
None
To Next Page
Loading...
