Electra Elite IPK II Document Revision 1
Clock/Calendar Display 2 - 197
Clock/Calendar Display
Description
The system uses Clock/Calendar Display for:
Using the Daylight Savings Setup program, you can determine whether the system should automatically
adjust the system time for daylight savings time/standard time changes.
Clock Adjustment
The system can be programmed to automatically adjust the system clock on a nightly basis. This feature
allows you to make adjustments should the system cabinet regularly lose or gain time.
Conditions
The system retains the Clock/Calendar Display after a power failure or system reset.
Changing the time may change the current Class Of Service (COS) service depending on
the COS mode setup.
You can program the system to automatically switch modes.
Single line telephones cannot set the time and date.
Changing the system time automatically changes the In-Mail time.
Default Setting
Enabled
J
Central Office Calls (Access Maps)
J
Station Message Detail Recording
J
Class of Service (Class)
J
System Reports
J
Direct Inward Lines
J
Toll Restriction (Class)
J
Display Telephones
J
Trunk Group Routing
J
Night Service (Automatic)
J
Voice Mail
J
Programmable Trunk Parameters
J
Voice Response System
J
Ring Groups
To Next Page
Loading...
