Document Revision 1 Electra Elite IPK II
2 - 214 Code Restriction, Dial Block
Required Component(s):
None
Related Features
None
Programming
11-10-17 Service Code Setup (for System Administration) – Dial Block by Supervisor
Assign a service code (601 by default) to be used by the supervisor to set Dial Block for another
extension.
11-11-33 Service Code Setup (for Setup/Entry Operation) – Dial Block
Assign a service code (600 by default) to be used for Dial Block.
20-06-01 Class of Service for Extensions
Assign a COS to each extension (1~15).
20-08-08 Code Restriction Dial Block
Enable (1) or disable (0) an extension’s ability to use Dial Block.
21-09-01 Dial Block Setup – Code Restriction Class with Dial Block
Assign a Code Restriction COS (1~15) when the Dial Block feature is used.
21-09-02 Dial Block Setup – Supervisor Password
Assign a 4-digit password to be used by the supervisor to enable or disable Dial Block for other
extensions.
21-10-01 Dial Block restriction Class per Extension
Assign the Code Restriction COS (1-15) to be used by an extension when the Dial Block feature
is enabled. If this data is “0”, Code Restriction COS follows PGM 21-09-01.
90-19-01 Dial Block Release
Enter the extension number to be released from the Dial Block Restriction. This program can be
used when a password is forgotten by the user.
To Next Page
Loading...
