Electra Elite IPK II Document Revision 1
Code Restriction 2 - 207
Toll Free Trunks
Certain trunks can be completely unrestricted, such as the company president’s Private
Line. Users can place calls on Code Free Trunks anytime – to anywhere, without
inadvertently being Code restricted.
PBX Call Restriction
Code Restriction programming lets you enable/disable PBX Call Restriction and enter PBX
access codes. You only need to do this if your system is behind a PBX and you have trunks
programmed for behind PBX operation. Refer to PBX Compatibility feature for the
specifics.
Additional Default Entries For Common Permit Code Table
Additional entries have been added to the default Common Permit Code Table. The default
setting is as follows:
Tie Line Code Restriction Enhanced
In
34-01-05 : E&M Tie Line Basic Setup - System Code Restriction, if this option is set to ’0’, the
system will follow the setting in
21-05-13 : Code Restriction Class - Restriction of Tie Line Calls to
determine whether or not the Code restriction setting in Program 34-08 is to be followed. If
this option is set to ’1’, the system will follow the system Code restriction settings defined in
Program 21-05-01 through 21-05-13.
A user can temporarily override a extension's Code Restrictions.
The system will allow or deny outgoing access to trunks depending on Code Restriction.
If the system detects the call is answered by detecting reversal in an analog trunk this
restores both way voice paths immediately.
When using DISA or tie lines, additional programming is required for Code Restriction
(DISA, refer to Program 25-10; tie lines, refer to Program 34-04).
A user can temporarily block their extension’s Code Restriction access, preventing
unwanted calls from being placed on their telephone while they are away from their desk.
Default Setting
Disabled
H
Table 1: 911
H
Table 4: 1822
H
Table 7: 1855
H
Table 2: 1800
H
Table 5: 1833
H
Table 8: 1866
H
Table 3: 1888
H
Table 6: 1844
H
Table 9: 1877
To Next Page
Loading...
