Electra Elite IPK II Document Revision 1
Code Restriction 2 - 211
21-06-07 Toll Restriction Table Data Setup - Restrict Code Table
Program codes into the Restrict Code Tables (200 codes per table maximum).
21-06-08 Toll Restriction Table Data Setup - PBX Access Codes
The system allows up to 4 tables for PBX access codes. PBX Access Codes can be up to 2
digits, using 0~9, #, ∗ and LINE KEY 1 (don’t care). Refer to the PBX Compatibility feature for
the specifics.
21-21-01 Toll Restriction Class for Trunks (Seized Trunk Basis Setting) - Restriction Class
Toll restriction class for trucks. For each truck, assign a Class restriction Class for each Day/
Night Service Mode.
34-01-05 E&M Tie Line Basic Setup - System Toll Restriction
Enable (1) or disable (0) the ability for tie line calls to follow the system Toll Restriction entries in
Programs 21-05-01 through 21-05-13. If disabled, Tie Line Code Restriction will be determined
by 21-05-13.
34-08-01 Toll Restriction Data for E&M Tie Lines
Define the Toll Restriction data for E&M tie lines. This data should be defined if Tie Line Code
Restriction is enabled in Program 21-05-13.
Operation
To place a trunk call if your system is Code Restricted:
1. Place call normally.
If your Code Restriction Class does not allow the number you dial, your call will be cut off.
To Next Page
Loading...
