Document Revision 1 Electra Elite IPK II
2 - 360 D
term
Cordless Lite II Terminal
8. Press TALK to exit.
Function keys F1 ~ F4 can be programmed as Line Keys 1~16, Redial (LNR/SPD), Answer (ANS), Feature
(FNC), or Recall. When assigned, these keys operate the same as on an NEC Multiline Terminal.
When initially installed, function keys F1~F4 default to Line keys 1~4 respectively and Off-Hook Ringing
defaults to ON.
Global Off-Hook Ringing must be ON (default) for any function key to operate with off-hook ringing.
Switching Between the Desktop Multiline Telephone and the D
term
Cordless Lite Telephone
Using the Base Unit:
When the D
term
Cordless Lite II is associated with a Multiline Telephone the following is applicable:
J
Switching between the cordless mode and desk mode must be done while both telephones are
idle.
J
A call in progress can not be switched between the D
term
Cordless Lite II and the associated
Multiline Telephone.
J
Switching held calls between the D
term
Cordless Lite II Telephone and the associated Multiline
Telephone is not recommended because line key LED indications are not provided.
Switching from Multiline Telephone and D
term
Cordless Lite Telephone:
1. Press the Cordless button on the base unit.
- OR -
Press REDIAL key from the D
term
Cordless Lite II handset.
,
,
This applies only if the REDIAL key is programmed to perform desk to cordless switching.
To switch from D
term
Cordless Lite II Telephone to Multiline Telephone:
1. Press the DESK button on the base unit.
For additional Operating Procedures, refer to the D
term
Cordless Lite II (DTH-4R-1) Owner’s Guide.
To Next Page
Loading...
