Electra Elite IPK II Document Revision 1
Hotline 2 - 451
20-02-03 System Options for Multiline Telephones - BLF Control and
20-13-06 Class of Service Options (Supplementary Service) - Automatic off-hook Signaling
Programs 20-02-03 and 20-13-06 set the conditions under which a Hotline, Reverse Voice Over
or DSS Console key indicates that an extension is busy. With condition 1 in the following chart,
the BLF LED is on only when both extension line appearances are busy. In conditions 2~4, the
BLF LED is on when one line appearance is busy.
20-06-01 Class of Service for Extensions
Assign a Class of Service to an extension (1~15).
20-11-06 Unscreened Transfer
0 = Off
1 = On
20-11-11 Automatic Off-Hook Transfer
0 = Off
1 = On
22-01-01 System Options for Incoming Calls, Incoming Call Priority
Use this option to determine if intercom calls or trunk calls have answer priority when both are
ringing simultaneously (0 = Intercom Call Priority, 1 = Trunk Call Priority). Refer to Program
15-02-22 for lamping conditions.
30-05-01 DSS Console Lamp Table
If required, use this program to customize the system’s DSS Console flash rates. This table also
affects DSS/Hotline key lamping for multiline terminals.
Operation
To place a call to your Hotline partner:
1. Press the Hotline key (PGM 15-07 or SC 751: 01 + partner’s extension number).
You can optionally lift the handset after this step for privacy.
Program 20-13-06 Program 20-02-03
BLF
1
Status
Busy
Status
11 0OffNo
21 1OnYes
30 0OnYes
40 1OnYes
1
BLF is on for extension receiving a voice announced Intercom call.
To Next Page
Loading...
