NEC ELECTRA ELITE IPK II - Page 504

Document Revision 1 Electra Elite IPK II
2 - 482 IP Station (MEGACO) - MG 16
6. 84-11-06 G711 Jitter Buffer Max –values are set in “ms” (default: 120ms)
7. 84-11-07 G729 Audio Frame [1=10ms, 2=20ms, 3=30ms] (default: 3=30ms)
8. 84-11-08 G729 VAD Mode (default: 0:Disable)
9. 84-11-09 G729 Jitter Buffer Min – values are set in “ms” (default: 30ms)
10. 84-11-10 G29 Jitter Buffer Type – values are set in “ms” (default: 60ms)
11. 84-11-11 G729 Jitter Buffer Max – values are set in “ms” (default: 120ms)
12. 84-11-17 Jitter Buffer Mode – supported Static or Immediate (default: 2: Immediate)
13. 84-11-18 Voice Activity Detection Threshold – values set in “db” [default: 20= 0db(-30dbm)]
14. 84-11-20 Echo Canceller Mode (default: 1:Enable)
15. 84-11-22 Non-Linear Processing Echo Canceller Mode (default: 1:Enable)
16. 84-11-22 Non-Linear Processing Echo Canceller Mode (default: 1:Enable)
17. 84-11-22 TX Gain (default: 10)
18. 84-11-22 RX Gain (default: 10)
84-11-28 : D
term
IP Codec Information Settings - Audio Priority
For each Type, set the codec to use (default = G.711). By default, all IP Phones belong in Type 1.
To change the Type for an IP Phone:
15-05-15 : IP Phone Terminal Basic Data Setup - CODEC Type
For each IP Phone (extension number), select the Type to use (default = 1).
System Tones and Ring Tones:
System IP Phones do not use Program 80-01 : Service Tone Setup entries. The tones are generated
locally by the System IP Phone. When a Door Box chime rings a System IP Phone, the system activates
the chimes using a ring command. Because of this, if the volume is adjusted while the door chime is
sounding, the ringing volume of the System IP Phone will be adjusted.