Electra Elite IPK II Document Revision 1
Analog Communications Interface (ACI) 2 - 33
Physical Ports and Software Ports
Each PGD(2)-U10 ADP consists of a physical port for connection to the telephone system and two logical
ports. For programming purposes, the ports are also called software ports. The physical port connects to a
station position on a ESI ETU. During installation, the first PGD(2)-U10 ADP you set up is physical port 1;
the second PGD(2)-U10 ADP is physical port 2, etc. Each PGD(2)-U10 ADP has two software ports,
which are numbered independently of the physical ports. Normally, the first PGD(2)-U10 ADP set up has
software ports 1-2; the second PGD(2)-U10 ADP has software ports 3-4, etc. There are a total of 96
software ports (48 PGD(2)-U10 ADPs x 2 ports each). During programming, you assign ACI extension
numbers and Department Group options to PGD(2)-U10 ADP software ports, not physical ports. During
installation, you connect equipment to the jacks on the PGD(2)-U10 ADP that correspond to the software
port. Refer to the Electra Elite IPK II System Hardware Manual for installation details.
Conditions
ACD agents who are logged on can be recorded.
ACI software ports cannot be Background Music music sources.
An extension cannot have Hotline keys for ACI software ports. Music on Hold ACI software
ports can be Music on Hold music sources.
An extension can have One-Touch Keys for ACI software ports. The gives the extension
user:
J
One-Touch access to external music
J
One-Touch External Paging
J
One-Touch loud ringer control
ACI software ports can provide External Paging with control, independent of the External
Paging circuits on the CPUII ETU. The PGD(2)-U10 ADP can only be connected to an
ESIB(8)-U20 ETU. If the PGD(2)-U10 ADP is connected to an ESIE(8)-U20 ETU, the
PGD(2)-U10 ADP will NOT be recognized.
When an ESIB(8)-U20 ETU has an ESIE(8)-U20 ETU installed [ESIB/E(16)], the
PGD(2)-U10 ADP will have both channels available for Paging, MOH, External Ringers,
and Door Box according to strapping on ports 1-8. The corresponding port on the
ESIE(8)-U20 ETU will not support a station or other hardware (it is used by the PGD(2)-U10
ADP for channel 2).
When an ESIB(8)-U20 ETU is installed without an ESIE(8)-U20 ETU installed, a
PGD(2)-U10 ADP installed on ports 1~8 will be recognized, but only Channel 1 on the
PGD(2)-U10 ADP is supported. Channel 2 is not available.
ESIB(8)-U10 ETUs and ESIE(8)-U10 ETUs do not support the PGD(2)-U10 ADP.
To Next Page
Loading...
