Document Revision 1 Electra Elite IPK II
2 - 550 K-CCIS - T1
Direct access of K-CCIS voice or data channels using Line keys or Specified Line Seizure
access codes is prohibited.
The Recall key or Drop key does not function on K-CCIS calls. When either key is pressed,
operation is ignored, and the call continues.
Trunk queuing is prohibited on a K-CCIS trunk route.
The ability to route an incoming DID call directly across a K-CCIS link (Direct Inward Dialing
– K-CCIS) is supported only when a Closed Numbering Plan using F-Routes is used.
This feature is not supported by the TLI(2)-U( ) Analog Line interface.
Only one CCH(4)-U( ) ETU can be assigned per system.
Extension numbers cannot start with 0 or 9.
Internal Calls, transferred calls, and K-CCIS calls do not provide Caller ID to single line
telephones.
Caller ID Call Return feature is not supported with K-CCIS calls.
Default Setting
Not installed
System Availability
Terminals
All Stations
Required Component(s)
DTI-U30 ETU or higher
CCH(4)-U( ) ETU with firmware 5.0X or higher
The following table shows the KSU system software compatibility with CCH(4)-U( )
firmware and K-CCIS feature compatibility.
KSU Software CCH V5.XX
IPK II V1000 V1.0X X
X = Compatible
– = Not Compatible
To Next Page
Loading...
