Electra Elite IPK II Document Revision 1
Analog Communications Interface (ACI) 2 - 37
Operation
To call an ACI software port:
1. Press the idle Speaker key.
2. Dial ACI software port extension number.
- OR -
Dial ACI Department Group extension number.
- OR -
Press the One-Touch Key for ACI extension or Department Group.
After you call an ACI software port:
J
If the port is set for input (Program 33-01-01=1) and a music source is connected, you hear music.
- OR -
J
If the port is set for output (Program 33-01-01=2) and External Paging is connected, you can page
into the external zone.
- OR -
J
If the port is set for output (Program 33-01-01=2) and a loud ringer is connected, you activate the
loud ringer.
To manually record a call an ACI software port:
1. While on a call, press the ACI Conversation Record key (PGM 15-07 or SC 751: 69 + 0).
The key’s LED will be lit when recording.
2. To stop recording, press the ACI Conversation Record key once again.
The key’s LED will be off when recording has stopped.
To Next Page
Loading...
