Document Revision 1 Electra Elite IPK II
2 - 602 Multiple Trunk Types
20-14-01~12
Class of Service Options for DISA/E&M
Enable (1) or disable (0) the following options for each Tie Line Class of Service (1~15):
01 First Digit Absorption (Delete First Digit Dialed)
02 Trunk Group Routing/ARS Access
03 Trunk Group Access
04 Outgoing System Speed Dial
05 Operator Calling
06 Internal Paging
07 External Paging
08 Direct Trunk Access
09 Forced Trunk Disconnect <Not for ISDN T-point>
10 Call Forward Setting by Remote via DISA
11 DISA/Tie Trunk Barge In
12 Retrieve Park Hold
21-05-01 Toll Restriction Class - International Call Restriction Table
21-05-02 Toll Restriction Class - International Call Permit Table
21-05-04 Toll Restriction Class - Maximum Number of Digits Table Assignments
21-05-05 Toll Restriction Class - Common Permit Code Table
21-05-06 Toll Restriction Class - Common Restrict Code Table
21-05-07 Toll Restriction Class - Permit Code Table
21-05-08 Toll Restriction Class - Restrict Code Table
21-05-09 Toll Restriction Class - Restriction for Common Abbreviated Dialing
21-05-10 Toll Restriction Class - Restriction for Group Abbreviated Dialing Numbers
21-05-11 Toll Restriction Class - Intercom Call Restriction
21-05-12 Toll Restriction Class - PBX Call Restriction
If Program 34-01-05 is set to (1), define the toll restriction settings for Tie Lines.
21-05-13 Toll Restriction Class - Restriction of Tie Line Calls
Enable (1) or disable (0) toll restriction for Tie Line calls (defined in Program 34-08-01).
22-02-01 Incoming Call Trunk Setup
For each Night Service mode, enter service type 5 when the trunk should be a tie trunk.
34-01-01 E&M Tie Line Basic Setup - DID/E&M Start Signaling
Enter 0 for 2nd dial tone, 1 for wink, 2 for immediate, or 3 for delay start signaling. To set
outgoing signaling, refer to Program 14-02-01.
To Next Page
Loading...
