Document Revision 1 Electra Elite IPK II
2 - 738 Selectable Display Messaging
Operation
To select a message:
1. Press the Speaker key + press the Text Message key (PGM 15-07 or SC 751: 18) + enter digits to
append (if needed) + Speaker to hang up. Skip the remaining steps.
2. (Optional for messages 1~8 and 10.)
Dial the digits you want to append to the message.
You can append messages 1-8 and 10 with digits (e.g., the time when you will be back). You enter the time in
24-hour format.
3. Press the Speaker key to hang up.
Intercom calls to extensions with Selectable Display Messaging set will receive a DND signal and receive the
display message on their telephone’s display instead of ringing the extension based on the setting in Program
20-01-02.
To allow calls to ring through and have the message displayed on the calling extension’s display, cancel DND by
pressing DND + 0.
To cancel a message:
1. Press the Speaker key + press the Text Message key (PGM 15-07 or SC 751: 18).
2. Press Speaker to hang up.
Using the Text Message Service Code to select a message:
1. Press the Speaker key + dial the Text Message service code (Program 11-11-14).
2. Dial the Selectable Display Message number to be used (01~20).
(Optional messages 1~8, and 10, dial the digits you want to append to the message.)
3. Press Speaker to hang up.
To cancel, repeat Step 1 and hang up.
# Accepts a numeric entry from the user when setting
a display message.
e.g., time or date. Back at ##:##
Conf Clear the character entry one character at a time.
Hold Clear all the entries from the point of the flashing
cursor and to the right.
Table 2-18 Selectable Display Message - Character Entry Chart
Use this keypad digit . . . When you want to. . .
To Next Page
Loading...
