Electra Elite IPK II Document Revision 1
Single Line Telephones, Analog 500/2500 Sets 2 - 747
Related Features
Single line telephone users have access to the following features:
Data Communications
APA and APR modules can be used with Multiline terminals to provide an analog port.
Refer to the individual features for additional descriptive, programming and operational information.
Programming
10-03-01 Terminal Type (B1)
Program all on-premise 500/2500 type single line telephones with circuit type ‘2’. Set the DIOPU
trunk to type ‘1’ when trunks should be defined for off-premise extension (OPX) use.
10-03-03 ETU Setup, For SLIU Unit - Transmit Gain Level (S-Level)
10-03-04 ETU Setup, For SLIU Unit - Receive Gain Level (R-Level)
Assign transmit and receive levels for 500/2500 type single line telephones.
10-09-01 DTMF and Dial Tone Circuit Setup
If the system has 2500 type (DTMF) single line extensions, allocate at least one circuit for
analog extension DTMF reception (entry 0 or 1).
Use the following as a guide when allocating DTMF receivers:
H
Speed Dialing
H
Account Codes
H
Alarm
H
Automatic Route Selection
H
Barge-In
H
Call Forwarding
H
Call Forwarding with Follow Me
H
Call Forwarding/DND Override
H
Call Waiting/Camp On with Split
H
Callback
H
Central Office Calls, Answering
H
Central Office Calls, Placing
H
Conference
H
Department Calling
H
Department Step Calling
H
Directed Call Pickup
H
Do Not Disturb
H
Door Box
H
Flash
H
Forced Trunk Disconnect
H
Group Call Pickup
H
Hold
H
Intercom
H
Handsfree Answerback/Forced
Intercom Ringing
H
Last Number Redial
H
Line Preference
H
Meet Me Conference
H
Meet Me Paging
H
Meet Me Paging Transfer
H
Message Waiting
H
Night Service
H
Off-Hook Signaling
H
Paging
H
PBX Compatibility
H
Pulse to Tone Conversion
H
Ringdown Extension
H
Save Number Dialed
H
Selectable Display Messages
H
Toll Restriction
H
Transfer
H
Trunk Queuing and Camp On
H
Voice Mail
H
Voice Over
H
Warning Tone for Long Conversation
To Next Page
Loading...
