NEC ELECTRA ELITE IPK II - Page 787

Electra Elite IPK II Document Revision 1
Speed Dial - System/Group/Station 2 - 765
7. Press Hold.
8. Press the Speaker key to hang up.
To dial a Station Speed Dialing number:
1. Press the Speaker key.
2. Dial #7 (default Service Code).
- OR -
Press the System Speed Dialing key (Service Code 751: 27).
 To preselect, press a line key in step 1 (instead of Speaker).
3. Dial the Station Speed Dial buffer number (1~9).
1 = Station Speed Dial buffer 1
2 = Station Speed Dial buffer 2
" " " " " "
0 = Station Speed Dial buffer 10
 The stored number dials out.
 Unless you preselect, Trunk Group Routing selects the trunk for the call. The system may optionally select a
specific Trunk Group for the call.
 If you have a DSS Console, you may be able to press a DSS Console key to chain to a stored number.
, Enter characters:
, + , - . / : ; < = > ? B E σ S ∞ ¢ £
# # = Accepts an entry (only required if two letters on the same key are needed - ex: TOM).
Pressing # again = Space.
Conf Clears the character entry one character at a time (used when entering the name).
Exit
Clears all the entries from the point of the flashing cursor and to the right (used when
entering the number, this clears both the number and name).
Key for Entering Names (Continued)
Use this keypad
digit . . .
When you want to. . .