NEC ELECTRA ELITE IPK II - Page 810

Document Revision 1 Electra Elite IPK II
2 - 788 Station Message Detail Recording
 10-20-01 LAN Setup for External Equipment
Define the TCP port (0-65535) when communicating to the SMDR (type 5).
 10-21-02 CPUII Hardware Setup - Baud Rate for COM Port
If the SMDR connection is made using the COM port on the CPUII, define the baud rate.
Baud Rates:
0 = 4800
1 = 9600
2 = 19200
3 = 38400
 14-01-06 Basic Trunk Data Setup - SMDR Print Out
For each trunk, enter 1 if trunk’s calls should appear on SMDR report. Enter 0 if trunk’s calls
should not appear on SMDR report.
 15-01-03 Basic Extension Data Setup - SMDR Printout
For each extension, enter 1 if extension’s calls should appear on SMDR report. Enter 0 if
extension’s calls should not appear on SMDR report.
 15-02-19 Multiline Telephone Basic Data Setup - CTA/CTU Data Communication Mode
Select ‘0’ if the dip switch settings are set to PC connection or select ‘1’ if printer/SMDR
connection is selected on the CTA/CTU adapter.
 15-02-20 Multiline Telephone Basic Data Setup - Baud Rate for CTA Port
Set the baud rate to be used by the CTA.
Baud Rates:
0 = 4800
1 = 9600
2 = 19200
 35-01-01 SMDR Options - Output Port Type
Specify the type of connection used for SMDR. The baud rate for the COM port should be set in
Program 10-21-02 or 15-02-20.
Connection Types:
0 = No Setting
1 = COM (KSI - COM 1 port)
2 = Not Used)
3 = L:AN (CPUII LAN output)
4 = CTA/CTU
 35-01-02 SMDR Options - Output Destination Number
Specify the SMDR printer output port (CTA/CTU extension number).