NEC ELECTRA ELITE IPK II - Page 94

Document Revision 1 Electra Elite IPK II
2 - 72 Automatic Route Selection
 44-04-01 ARS/F-Route Selection for Time Schedule
Assign each ARS/F-Route Selection number (1~500) to an ARS/F-Route table number for each
ARS/F-Route time mode. There are eight time modes for ARS/F-Route Access.
 44-05-01 ARS/F-Route Table - Trunk Group Number
For each ARS/F-Route table (1~500) assign a priority number (1~4) and enter the trunk number
to be used.
0 = No Setting
101~150 = Networking
255 = Extension Call
 44-05-02 ARS/F-Route Table - Delete Digits
For each ARS/F-Route table (1~500) assign a priority number (1~4). Enter the number of digits
to be deleted (0~255) from the dialed number.
 44-05-03 ARS/F-Route Table - Additional Dial Number Table
For each ARS/F-Route table (1~500) assign a priority number (1~4). Enter the table number
(defined in Program 44-06) for additional digits to be dialed (0~1000).
 44-05-04 ARS/F-Route Table - Beep Tone
For each ARS/F-Route table (1~500) assign a priority number (1~4). Select whether or not a
beep is heard if a lower priority trunk group is used.
0 = No Beep
1 = Beep
 44-05-05 ARS/F-Route Table - Gain Table Number for Internal Call
For each ARS/F-Route table (1~500) assign a priority number (1~4). Select the gain table
number to be used for internal calls (0~500).
 44-05-06 ARS/F-Route Table - Gain Table Number for Tandem Connections
For each ARS/F-Route table (1~500) assign a priority number (1~4). Select the gain table
number to be used for tandem connection (0~500).
 44-05-07 ARS/F-Route Table - ARS Class of Service
For each ARS/F-Route table (1~500) assign a priority number (1~4). Select the Class of Service
to be used for ARS (0~16). An extension’s ARS COS is determined in Program 26-04-01.
 44-05-08 ARS/F-Route Table - Dial Treatment
For each ARS/F-Route table (1~500) assign a priority number (1~4). Select the Dial Treatment
to be used (0~15). The Dial Treatments are defined in Program 26-03-01.
 44-05-09 ARS/F-Route - Max Digit Assignment
For each ARS/F-Route table (1~500) assign the priority (1~4). Set the maximum digits to be
dialed (1~99) for each ARS/F-Route table.