NEC ELECTRA ELITE IPK II - Page 960

Document Revision 1 Electra Elite IPK II
2 - 938 Voice Over Internet Protocol (VoIP)
Programming - Electra Elite IPK II IP Multiline Terminal or Electra Elite IPK II Multiline Terminal
with IP Adapter, Static IP Address
Setting the IP Address on an Electra Elite IPK II IPhone or Electra Elite IPK II Multiline Terminal with IP
Adapter Using a Static IP Address
1. On the Electra Elite IPK II IP multiline terminal, enter the telephone’s program mode by pressing
Hold Conf
∗ #.
 This enters the IP User Menu program mode to select the settings for the individual telephone.
 To enter the telephone’s program mode, the display must show the time, error, or “Connecting” message prior
to pressing Hold Conf ∗ #.
2. Press 1 (Network Settings).
3. Select 1 for DHCP mode. If not flashing, press 1 to disable the DHCP mode. Press the soft key
OK.
 The flashing item is the current selection.
Figure 2-13 Selecting Network Settings Menu