Electra Elite IPK II Document Revision 1
Voice Response System (VRS) 2 - 953
20-15-11 Ring Cycle Setup, VRS Waiting Message Incoming Call
Set the ring cycle callers hear when the VRS Waiting Message feature is used.
21-01-02 System Options for Outgoing Calls - Intercom Interdigit Time
Automated Attendant callers must dial digits within this interval. If the caller does not, they hear
busy tone and must hang up and dial again.
22-01-10 System Options for Incoming Calls, VRS Waiting Message Operation
Determine whether the VRS Waiting Message is automatically (0) or manually (1) set.
22-01-11 System Options for Incoming Calls, VRS Waiting Message Interval Time
For VRS Waiting Message, determine the number of seconds between the VRS messages
(0~64800).
22-02-01 Incoming Call Trunk Setup
For each Night Service mode, enter 1 if trunk should be automatically answered by VRS
Automated Attendant.
22-04-01 Incoming Extension Ring Group Assignment
Assign extensions to the Ring Group programmed in 25-03 and 25-04 that should receive the
rerouted calls.
22-14-01 VRS Delayed Message for IRG, 1st Waiting Message Start Time
For each Ring Group, set how long the system waits before playing the first message (0~64800
seconds). This timer is also used for VRS Waiting Message.
22-14-02 VRS Delayed Message for IRG, 1st Waiting Message Number
For each Ring Group, select the message number to be played as the first message (0~48).
This program is also used for VRS Waiting Message.
22-14-03 VRS Delayed Message for IRG, 1st Waiting Message Sending Count
For each Ring Group, set the number of times the first message will be played (0-255). This
program is also used for VRS Waiting Message.
22-14-04 VRS Delayed Message for IRG, 2nd Waiting Message Number
For each Ring Group, select the message number to be played as the second message (0~48).
This program is also used for VRS Waiting Message.
22-14-05 VRS Delayed Message for IRG, 2nd Waiting Message Sending Count
For each Ring Group, set the number of times the first message will be played (0-255). This
program is also used for VRS Waiting Message.
22-14-06 VRS Delayed Message for IRG, Tone Kind at Message Interval
For each Ring Group, determine what the caller will hear between messages (0 = Ringback
Tone, 1 = MOH, 2 = BGM). This program is also used for VRS Waiting Message.
To Next Page
Loading...
