Document Revision 1 Electra Elite IPK II
2 - 968 Wireless - DECT
J
Programming Pause
A long press on
_ adds a pause to pre-dial or phone book numbers.
J
Programming of 2 Different Setups
Each handset can program two profiles to control ring tone and vibrator. One can be an indoor
setting; the other, an outdoor setting.
J
Adjustable Volume
Ring volume can be adjusted using > and < in the profile setup.
J
Key Lock
Press Menu and * to lock the dial pad.
J
Nine Different Ring Tones
Ring tones can be selected using > and <.
J
Microphone Mute
Press OK while the telephone is off-hook to mute the microphone.
J
Caller ID Presentation
J
Headset Connection
J
Automatic Off-Hook
B-Answer can be turned On/Off using > and < in the profile setup. When set to On, the telephone
automatically goes off-hook when it rings.
J
R-Key for Transfer and Special Services
When off-hook, press R to Recall, transfer.
Base Station
The Base Station provides the link between the IPK Wireless – DECT telephone and the Electra Elite
IPK II system. Base Stations are connected to the BSU( )-U20 ETU using standard two wire (twisted
pair) telephone cable, CAT 4 or CAT 5. The maximum distance from the BSU( )-U20 ETU to the Base
Station is 3,280 feet. Local power is not required because the Base Station receives power from the IPK
II system. Up to 16 Base Stations can be connected to the system. Each Base Station supports four
simultaneous IPK II Wireless – DECT traffic channels at 32 Kbs.
Repeater
The Repeater allows extended coverage for low traffic areas not covered by a Base Station. Sufficient
coverage for the main traffic area should be provided by the Base Station. An external antenna can also
be connected to extend the coverage area. Local power is required for the Repeater (within 6 feet) and
must be synchronized with a Base Station in the zone providing coverage. The Repeater is
synchronized with the Base Station using the Repeater Programming Kit that provides an RS232 cable
to connect the Repeater to a PC. A Windows application is used to define the Base Station that should
To Next Page
Loading...
