NEC Univerge SV8100 - Page 1206

Issue 1.0 UNIVERGE SV8100
2 - 1182 Uniform Call Distribution (UCD)
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15) to
an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
3
20-09-07 Class of Service Options
(Incoming Call Service) – Call
Queuing
Turns Off (0) or On (1) an extension
ability to have calls queued if a call
rings the extension when it is busy.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-11-17 Class of Service Options (Hold/
Transfer Service) – Department
Group Trunk-to-Trunk Transfer
(Each Telephone Group Transfer)
Turns On (1) or Off (0) the ability of
an extension in a Department
Group to use the Trunk-to-Trunk
Forwarding service codes.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-13-06 Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
Allows a busy extension ability to
Manually (0) or Automatically (1)
receive Off-Hook Signals.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-13-14 Class of Service Options
(Supplementary Service) –
Department Calling (PLT No
Called Extension)
Turns Off or On an extension user
ability to call a Department Group
Pilot.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
22-02-01 Incoming Call Trunk Setup If you want a trunk to be a DIL to a
Department Group, assign Service
Type 4 for each Night Service
Mode. Also see Program 22-07-01.
0 = Normal
1 = VRS (second dial
tone if no VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
3
22-07-01 DIL Assignment For each trunk assigned Service
Type 4 in Program 22-02 above,
assign the DIL destination as the
Department Group pilot number (as
assigned in Program 11-07-01).
(Department: Groups 1~64).
Extension Number
(maximum eight digits)
(default not assigned)
3
24-02-05 System Options for Transfer –
Message Wait Ring Interval Time
For Single Line Telephones (SLTs)
without message waiting lamps,
this is the time between intermittent
ringing. If this value is set to 0, the
system rings once.
0~64800 (seconds)
(default = 30 seconds)
3
24-02-08 System Options for Transfer –
Delayed Transfer Timer for All
Department Groups
Determine how long a call should
ring a Department Group before
transferring the call.
0~64800 (seconds)
(default = 10 seconds)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3